|
|
|
 |
|
|
|
|
|
Mechanical Properties for 1.00 OD x .065 Wall Tubing: |
|
|||||||||||||||||||||||||||||||||||||||||
|
|
|
|
|
|
* (.5% Ext. under Load) |
|||
|
Drawn - General Purpose (H58)Temper is used for general purpose tube only, usually where there is no real requirement for high strength or hardness on the one hand or for bending qualities on the other. |
|||
|
Hard Drawn (H80)Temper is used only where there is need for a tube as hard or as strong as is commercially feasible for the size in question. |
|||
|
Light Drawn - Bending (H55)Temper is used only where a tube of some stiffness, but yet capable of readily being bent (or otherwise moderately cold worked) is needed. |
|||
|
Typical Uses: Household: air conditioners, gas lines, heater lines, oil burner tubes, plumbing tube, refrigerators, Industrial: brewery tubes, condenser, evaporator and heat exchanger tubes, dairy tubes, distiller tubes, steam and water lines, gasoline, hydraulic and oil lines. |
|||
|
The values listed above represent reasonable approximations suitable for general engineering use. They should not be used for specification purposed. See applicable A.S.T.M specification references. |
|||
|
||
|
